10 Metre Camera Cable with 4-Pin Connectors – LG9002

The LG9002 is a 10-metre extension cable with matched 4-pin connectors, designed as a direct, plug-and-play link between camera and monitor on LED-Global wired camera systems LG9001 and LG9005. It is CE approved and built for vehicle use, helping installers achieve a clean install and a stable camera feed in demanding working conditions.

The cable is a practical fit for vans, rigid trucks, trailers, plant equipment and agricultural machinery where reliable camera-to-monitor connections are needed without splicing or rewiring.

Plug-and-Play with LG9001 and LG9005 Systems

The LG9002 uses 4-pin connectors matched to the pin-out of the LG9001 and LG9005 camera systems. This removes guesswork from the install: route the cable, plug one end into the camera and the other into the monitor harness, and the system works without adapters or splicing into fragile video conductors.

Stable Signal and Secure Connection

The 4-pin screw-type interface gives a secure mechanical lock that helps prevent disconnection from vibration or vehicle movement. The cable is engineered for stable video signal transmission from camera to monitor, helping reduce image drop-outs and intermittent faults in daily fleet use.

Suitable Length for Most Vehicles

At 10 metres, the cable is long enough for most vans, rigid trucks, plant machinery and trailers, without leaving large coils of spare cable to secure inside the vehicle.

CE Approved for European Fleets

The LG9002 is CE approved, supporting safe and compliant installation across European commercial fleets. The construction is suitable for routing through chassis rails, body cavities and trunking in mobile applications.

Key Features

• 10-metre cable length for most vans, rigids, plant and trailers.
• Matched 4-pin connectors for LG9001 and LG9005 camera systems.
• Secure 4-pin screw-type interface for vibration resistance.
• Stable signal transmission for reliable camera-to-monitor video.
• CE approved for European fleet use.
• Vehicle-ready construction suitable for chassis and body routing.
• Plug-and-play install with no soldering or splicing required.
• Designed as a tested system component for LED-Global camera kits.

Ideal Applications

• Rigid trucks and tippers running LG9001 or LG9005 rear-view or side-view camera systems.
• Light commercial vehicles and vans needing a clean camera-to-monitor connection.
• Plant and construction machinery requiring vibration-resistant 4-pin connections.
• Agricultural equipment with cab monitors and rear or implement-mounted cameras.
• Recovery, utility and service vehicles in daily professional use.

Important Fitment Note

Please confirm camera and monitor compatibility, connector type and cable route before installation. Avoid sharp edges and high-heat zones during routing. For best results, the cable should be installed by a competent vehicle electrician or professional installer.